InterVlan Routing tiene problemas

[Detectorup]

Simplemente no puedo hacer que vlan10 y vlan 20 puedan interconectarse
Router OS pcx86 ver 5.20
interface ether1 : vlan 10 192.168.10.1/24
interface ether1: vlan 20 192.1682.0.1/24

conecto Mikrotik ether1---------------------------f0/0(TRUNK) Switch Cisco

En este switch Cisco capa2 tengo (vlan 10 y vlan 20)
donde tengo conectado en f0/1(vlan10) pc1 192.168.10.11/24 gw 192.168.10.1
y f0/2 (vlan20) tengo pc2 ip 192.168.20.11 gw 192.16820.1

Pero simplemente enter pc1(vlan10) y pc2(vlan20) NO se pueden hacer ping , PORQUE , ?

parece simple pero ya me estoy volviendo loco


DEBAJO la configuracion


[admin@MikroTik] > ip address print detail
++++++++++++++++++++++++++++++++++
Flags: X - disabled, I - invalid, D - dynamic
0 address=192.168.2.1/24 network=192.168.2.0 interface=ether1 actual-interface=ether1

1 address=192.168.10.1/24 network=192.168.10.0 interface=ether1 actual-interface=ether1

2 address=192.168.20.1/24 network=192.168.20.0 interface=ether1 actual-interface=ether1

3 address=192.168.30.1/24 network=192.168.30.0 interface=ether1 actual-interface=ether1

[admin@MikroTik] > ip route print detail
++++++++++++++++++++++++++++
Flags: X - disabled, A - active, D - dynamic, C - connect, S - static, r - rip, b - bgp, o - ospf, m - mme, B - blackhole, U - unreachable, P - prohibit
0 ADC dst-address=192.168.2.0/24 pref-src=192.168.2.1 gateway=ether1 gateway-status=ether1 reachable distance=0 scope=10

1 ADC dst-address=192.168.10.0/24 pref-src=192.168.10.1 gateway=ether1 gateway-status=ether1 reachable distance=0 scope=10

2 ADC dst-address=192.168.20.0/24 pref-src=192.168.20.1 gateway=ether1 gateway-status=ether1 reachable distance=0 scope=10

3 ADC dst-address=192.168.30.0/24 pref-src=192.168.30.1 gateway=ether1 gateway-status=ether1 reachable distance=0 scope=10


[admin@MikroTik] > interface ethernet print detail
+++++++++++++++++++++++++++++++++++++
Flags: X - disabled, R - running, S - slave
0 R name="ether1" mtu=1500 mac-address=00:0C:29:A9:B0:C5 arp=enabled disable-running-check=yes auto-negotiation=yes full-duplex=yes cable-settings=default
speed=100Mbps

 

[David Riveron]

https://drive.google.com/open?id=1BcWPJgkJfYLoIGj3F6MyJkT9cRznmev_